The LOST 5th WIP of Zudah non AB

This is an old old old post frm last year that i did not complete reason is I lost some of my picture due to corruption of my hdd last year. So this part will have some missing link to the final product.




So this is another way to cover the seam lines between 2 different parts, scribe them into panel line.




However not all parts of the mecha is suitable, just like the leg part shown below if you make a panel line in between them the MS will look abit awkward. So back to cementing... stick them back together.After they have dried up.... sand them up and you will be able to cover the gap between both parts.









Remember the earlier picture showing back of the hand with a panel line... this is the front part and i choose to cement it and the final product is like below.


Basically the whole Zudah is complete by now... leaving the touch up with weathering color. I would suggest you go buy the Gundam Weathering Marker to do the dirty job since it is much more easier and it wont damage your kit compare washing it with enamel paint (which i did so and some of my truster break off after doing so).

As for the weapon.... used the Burn Steel effect weathering marker to paint on it first then wipe them off with a cloth to create the metalic effect. Sry but i dun have the complete picture here since they are lost.


Apologize again for those ppl tat was following it earlier because most of the picture in the weathering part has been lost.... so thats all i can show. I will snap another picture of my final product sooner today.